Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Another attempt at a car.

WIP

1

2

1.9k

Log in to reply

M

Mike Amos
last edited by

I have tried making a low profile bonnet this time around, not something I normally get away with in sketchup. Usual huge dimensions of about 11 feet long by 65 inches wide. I went with the low bonnet because I would like to see a scooby motor in the front with rear wheel drive so front mid engined.
1 Reply Last reply
Reply Quote 0
M

Mike Amos
last edited by

Test for Firefox.
1 Reply Last reply
Reply Quote 0

Buy Vertex Tools

Buy SketchCuisine

Advertisement