[Plugin] FredoTools::Convexify - v1.0 - 25 Feb 15
-
Thanks for signaling.
This is a bug introduced by LibFredo6 6.8. Sorry for inconvenience.Please install LibFredo6 6.8c, now published on the PluginStore.
Fredo
-
speed and efficiency
a big applause
thank you a lot
is it possible to keep the exploded model? -
Will be fine if we can exit with an actual position of the animation Explode Convexify colored view!
(with colors or not)
Or does exist a trick ?
(sure I can use other thing like Explode-view, Animator, ... but that give not the colors etc...
-
-
It's seems to be relative with angular tolerance.
-
But I may be wrong…
-
Even more evident for 2 simple circles extruded!
Dashed lines should be the good ones!
-
Pilou,
This is normal.
The corresponding vertices of the inner and outer circles are not 'aligned', that is, the line joining two corresponding vertices does not go through the common center of the circles.
This is a frequent issue when drawing co-centric circles. Because they are made of segments, it may important to keep them 'aligned'. I must say that the Circle tool does not help too much for that.
If Convexify was 'following' your edges in the current model, the pieces would not be convex or would have to be divided in smaller chunks.
Fredo
-
That is some ennoyous!
So we must found a trick!
Because make drawings with concentric Circles or Arc-circle are very commune!
-
Ok I found one
Drawing concentric circles on the same alignment!
here the red axe!
PS Now if you can exit during the animation for keept the position of objects & colors
that will be cool!
Advertisement