Having some troubles putting a straight groove on a angle
-
@dweano said:
First off...fastest and most helpful forum ever.
We try.
@dweano said:
Second off: I can't believe I didn't notice that. Of course simple geometry dictates that they can't be on the same plane!
Uh, yeah. I was about to edit my previous post to include that. You were butting heads with Euclid or one of those other old, dead guys.
Notice with the geometry straightened out, it works out pretty.
-
So what did you do there? Bring the "front" (taller part) "waist" down? Thats what it looks like.
I need to keep the top part level and at that angle...and have at least from the "waist" up tapered. But if that taper starts lower down in the front I don't think that would be a problem...hmm...
-
Nope that ain't working...make the back skinnier? Will try that...
-
I made the horizontal edge at the higher end narrower to keep the same angle on the sides as at the lower end. I also revised the interior to eliminate the same issue.
-
Ah yes of course...Thank you SOO much. This 3d drafting stuff is tricky
-
Makes you wish you'd paid more attention in high school geometry, doesn't it?
-
That was awhile ago...haha
-
Hmm...that one you made. Why isn't it symmetrical? From the top corners to the vertical axis it is 3.3 and 3.7mm? The two slopes are different angles? Man this this is confusing me hard haha
-
All I did is use the angles you drew at the shorter end. I didn't change them. You had the angles different to begin with. What angle do you want them to be? Or maybe more to the point, what are the critical dimensions?
-
I am more of a noob that I thought haha. I gotta go back to the drawing board I think. Slope should be equal on both sides. Only a couple mm's on each side. But I will have to whip out the calipers and see what is what
-
Maybe it is time to start fresh with a new SketchUp model.
-
Yep that is what I am thinking. But first...supper time
-
Maybe it'll make more sense on a full stomach, too.
Advertisement