A New Model and a Challenge
-
Dear Solo,
Stainless-steel screws would work. Or, you could substitute dowels and peg the slats in place that way. McFeely's or some similar outfit probably also sells coated screws that are rust-resistant.
dh -
Nice work, David. I see a few missing mortises that would only take a few moments worth of work. I'm curious about what is going on with the rear rail on the ottoman. Why those lines and why is there a gap between the mortise and its tenon?
As to attaching the slats, I agree that stainless screws (or bronze) would be plenty strong. I would screw in from below and make sure I didn't come out the top.
For the front legs I would be inclined to laminate them thusly. The overlapping faces at the miters would give a strong joint and the grain on the curved parts could run generally the length of the curve. This is a common construction method for sawn boat keels and makes for very strong construction.
-
Dave,
You earn bonuses for finding a couple of flaws I missed and for spotting the missing mortises that I did know about. Anyone else up for the challenge?
Best,
dh -
Does the little line segment floating in space behind the chair count? The mortise on the bottom edge of the crest rail that is outlined but not punched in? The misalignment where the armrest meets the back leg? The peg not aligned with the hole in the arm rest? The incomplete notches in Back slats 1 and 6? Why aren't 1 and 6, 2 and 5 and 3 and 4 related components? What about component axis alignments? Many of them could stand some adjustment.
Should I stop, now?
-
You can stop anytime you like. I think you've won the challenge.
-
Sorry.
-
Have a beer Dave
-
Lol Dave, you gonna give David a modeling complex soon.
-
I'm just trying to keep my friend on the straight and narrow.
-
Don't be too hard on my good friend Dave R. His comments are always well-intentioned and most helpful. No worry that he'll give me a complex of any kind. (My Napoleon complex is a pre-existing condition.)
Advertisement