MSphysics Need help with action

[Larry3141]

How do I make the cylinder stay in side the wheel when it turns? Would like cylinder to roll in the slot as the wheel rotates.

have tried lots of shapes, nothing I have tried has worked.

Thanks, Larry

---

[ecati]

Would you share the skp file, please.

[Larry3141]

Thank you for the answer, here is the file....Larry

---

wheel action v1.skp

[ecati]

Follow these steps.

---

---

---

[ecati]

Click on the 3. picture.
I hope this is what you want.

[ecati]

Here is the skp file.

---

wheel action v1_ecati.skp

[Larry3141]

Very good. Can you contact me please (see file name.), I am not sure how to describe how I need for this to act. I added to your file but I can't get it to work right. I must be over looking something.

Thank you very much for your work, LEE

---

wheel action v1_ecati_LEE_615_969_0688.skp

[ecati]

1. The engine connection must be at the center of the wheel, not away.
2. Some settings should be as I do.
3. If you ask this question "http://sketchucation.com/forums/viewtopic.php?f=323&t=64521&start=60" you can get better solutions.

---

wheel action v1_ecati1.skp

[Larry3141]

Thanks, I slowed the rotation and it works. How do I make the cylinder fall back into the slot at the top position as it rotates? Does it have something to do with centrifugal force?

I very much appreciate your help, Larry

[ecati]

In my opinion, it is from the centrifugal force.
I can not help you with this because I do not have top level knowledge. If you ask this question "http://sketchucation.com/forums/viewtopic.php?f=323&t=64521&start=60" you can get better information.