Fur not even
-
Hello!
I have this problem making fur grow even over a bent surface. It seems the grass in my scence follows the surface "lines". Sorry, I donĀ“t know what these are called, but I canĀ“t erase them using soft erase.
Is there a way to make the surface even so the spread of grass grows even as well?
-
Probably your maximal number of objects per face is too small?
(I can't wait for Skatter any longer
) -
Strang how your surface seems even. I did the same and it was somewhat more even but far from acceptable.
IsnĀ“t there a better way?
-
If a draw lines similar to the dotted ones I canĀ“t seem to remove I get close to equal surfaces (area). It will now grow even, but this is not optimal.
-
You've got two controls. Max number per face and density.
If density is 1 per m2 you got an object each m2.
A face with 2m2 will get 2 objects, a face with 2m2 will get 4 objects and so on...
If you have max number set to 4 AND density of 2 per m2, a face of 1m2 get's 2 objects, a face of 2m2 gets 4 objects, a face 3m2 get's 4 objects and a face with 100m2 still get's 4 objects.
That's why splitting the face makes your settings create a better distribution. You should increase max number.
-
The example number of 2000 depends on the shown surface (mine was 5mx5m?, didn't save it), if your face is bigger, you should increase it more.
-
@jql said:
You've got two controls. Max number per face and density.
If density is 1 per m2 you got an object each m2.
A face with 2m2 will get 2 objects, a face with 2m2 will get 4 objects and so on...
If you have max number set to 4 AND density of 2 per m2, a face of 1m2 get's 2 objects, a face of 2m2 gets 4 objects, a face 3m2 get's 4 objects and a face with 100m2 still get's 4 objects.
That's why splitting the face makes your settings create a better distribution. You should increase max number.
I will try this. Thanks.
And thanks to Cotty as well of course.
-
You have this one also!
(free version is existing) -
Yep, I use that plugin as well. For trees.
Advertisement