Profile Builder 2 Problem
-
Installed... Pretty damn kool!
Made this great assembly that make a safer barrier around a race track.
So far two issues... How do I make profiles follow and keep there relative rotation to the face? This one is leaving the bottom face flat. and not rotating the wall assembly to the face to keep 90 degrees. Any ideas?
and when I save an assembly, SU crashes... but prolly a conflict so no biggie.
-
@krisidious said:
Installed... Pretty damn kool!
Made this great assembly that make a safer barrier around a race track.
So far two issues... How do I make profiles follow and keep there relative rotation to the face? This one is leaving the bottom face flat. and not rotating the wall assembly to the face to keep 90 degrees. Any ideas?
Have you tried playing with the 'Rotation' parameter for the profile?
-
The rotation isn't constant, so I put it at 90. as in stay 90 to the plane?
-
I don't think there is a way to do what you are asking (unless I am not understanding the problem, correctly). PB2 does not consider the orientation of the face that is attached to the edge of the path that you are 'following'
-
so what is the vertical rotation option for?
Mitch made a plugin that just about does it. I just need to figure out the process a bit better.
Advertisement