Help to get started
-
Hi I am having trouble getting started. Would someone please run me through the following: I want to draw a channel made from 2mm mild steel. 230mm long 50mm high and 50mm deep. On the 2 legs a matching slot 140mm X 10mm (each side)starting 40mm from an end,and 35mm from the bend and on the top face a 10mm hole on the centre Thanks Lem
-
Hi Lemuzz
I hope I've understand your need. Here is a small down and dirty model. What about legs ? (Technical english may differ
from what I think )MALAISE
-
@malaise said:
Hi Lemuzz
I hope I've understand your need. Here is a small down and dirty model. What about legs ? (Technical english may differ
from what I think )MALAISE
yes this is what I want. But with a slot on each leg and a hole on the remaining surface. Could you run me through how it is done? Thanks Lem
-
Advertisement