Toggle Continuous Line
-
It's easy enough to stop the rubber banding with Line Command (finishing one line starts the next at the close point) by hitting escape. However, when stitching curves the lines don't continue once a face closes. You can spend all afternoon double clicking Line on a complex model.
Could the rubber banding be toggled, like Duplicate/Move, so we can choose on the fly? It's a pain when it isn't there and you need it, and just as frustrating when you don't want it and it happens anyway.
Thanks,
Jim
-
You can turn off "rubber banding" in Preferences -> Drawing -> untick "continute line drawing".
I personally find the rubber banding very useful. Though I do agree that sometimes termination of the rubber banding when a face is created can be a bit annoying when you are trying to close off multiple attached faces.
-
I think it would be a lot better to have it permanently on. Having to press escape is very little hassle compared to double clicking to keep your line going.
-
I guess you're right, Coen, it's better on than off. Still, but what's the difficulty of programming the option key, as it is programmed in Move, for example? Except keep it sticky, so that once it's engaged it stays that way until turned off.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
Advertisement