[Plugin] Pipe Tool (UPDATE 3/19/2011)
-
There, I updated my profile!
Yes, I e-mailed them.
-
@markis100 said:
God I wish somebody would create something for real layouts. Piping is so difficult in sketch up. Wake up Trimble
I feel your pain. Orginally found Sketchup almost three years ago while looking for a 3d program to draw process systems with. This is one of the better plugins I've found but it could use a lot of work. I've tried the 3skeng plugin and it is GREAT, but they don't seem to be much concerned about making components for us imperial users and communicating in English with them seems to be a problem. I've gotten no response to several emails in the past.
-
I hope enough support gets behind sketch up to encourage companies (trimble included) to develop more useful tools. Still lacks a lot of basic concepts, like hatching a concrete wall when you run a section through it.
On a postive note, I just got on a beta test list for a new plugin called pipedraft. Sounds promising. You should check it out. http://Www.pipedraft.com
-
@unknownuser said:
Normally a simple plugin don't work in Pc and Mac without special different codes ?
maybe it uses win32 type stuff?
sort of like if a plugin used applescript, it wouldn't work on pc..
-
<
@raineysky said:@markis100 said:
God I wish somebody would create something for real layouts. Piping is so difficult in sketch up. Wake up Trimble
.....
have you taken a look at the http://sketchup.engineeringtoolbox.com/? They have some AMSE and ANSI componets models that may be of use to you??
-
@unknownuser said:
have you taken a look at the http://sketchup.engineeringtoolbox.com/?
Awesome site for any kind of engineering information as well as the toolbox
-
@markis100 said:
On a postive note, I just got on a beta test list for a new plugin called pipedraft. Sounds promising. You should check it out. http://Www.pipedraft.com
That does look promising Markis!!! Please let us know what you think about it.
-
Loaded into SU 2013, signed in, created pipe, clicked on route pipe, clicked on start point, dragged cursor ....... nothing happens except pipe definition disappears.
Our system has pipes up to 18" diameter: program only goes to 4".
-
Have you tried the 3skeng plugin...?
-
OK, thanks. I have not tried it yet but then I will! I hope you do not mind my question
Advertisement