Need some Cad polyline/areas into table/Excel help..
-
Hi all,
Has anyone any advice or pointers for me with regards to transferring polyline/areas into a table or Excel? I'm close to figuring it out but seem to missing a few steps..
I'm running AutoCad 2007.Thanks for any help!
Cheers,
Nigel
-
Go through the AutoLISp section of CADtutor forum here, I am sure you will find it. If you can't find post a request, you will either be pointed to relevant posts or someone will write a routine for you. There is a very good (in AutoLISP) and helpful Russian guy there.
Guite
-
Thanks so much, Guite.
Those were great pointers and I definitely understand a lot better now.Cheers!
Nigel
-
You are welcome, Nigel. Hope you find what you are looking for, I remember seeing something similar discussed over there.
Guite
Advertisement