Panel optimizer for MAC?
-
Hello woodworkers.
I have a simple question - and I hope to get some answer.
Is there a panel optimizer software for MAC?
I'm not talking about using "Parallels" or "Fusion" to run windows on my MAC.
Just a software for MAC. Ideally "Cutlist +" for MAC.
I've spent so much time looking for it.
So... it does NOT exists... or I don't know where to look!
I've found ONE - Cabinet Cut, but it is so ... not good!
Any info very much appreciated!
Thank you! -
Cutlist 4.1 is available for free from the Extension Warehouse. It runs on a Mac just fine. And it will generate a cutting diagram that will show you how to optimize what you can get from sheet goods.
Hope this helps.
dh -
Thanks for input , but it does not support grain direction.
Thanks!
Advertisement