Hospital Interiors (Maxwell Render)
-
Probably a good point about the wall. Thanks. The camera position was a bit tricky. I was already going way overboard for what the interiors dept. was expecting. If I showed too much hallway I would have had to model some pretty tricky stuff. But I could have pulled it over or forward more and still been alright I think.
I actually reduced the glossiness a lot from where it was originally. The reflection from the 2x4 lights above was really strong. I need to make a good bump to give the floor tile some variation so the reflection doesn't give away that the floor is perfectly flat I think.
-Brodie
-
I know what you mean Brodes! There isn't a lot of control over MXI or HDRI even under Multilight.
Btw if next time you do use an MXI for the diffuser lights I'd suggest using two emitters, one hidden and one as the light panel glow! Using just the MXI as I did in the little insert picture, when adjusting the light up you can quickly burn out the effect you are after!
-
Wait, what? I thought that was a reference photo to illustrate your point? I should have known better with you!
-Brodie
-
@unknownuser said:
Wait, what? I thought that was a reference photo to illustrate your point? I should have known better with you!
-Brodie
Just about had you hey!
Here mate is the map for your MXI!
-
great work bro!
-
Richard, thanks. I'll adapt that and give it a shot on some ceiling fluoro's.
Thanks Teofas.
-Brodie
-
These are amazing. Well done pal I bet they took you ages.
-
Took about 16 hours of work time all together. Not too terrible I think. I'm working on a lobby for the same hospital at the moment. Hope it turns out as well.
-Brodie
Advertisement