Local Fire Company Engine
-
another note to self, I have to increase the door jamb size from 1/16" to something more noticeable.
-
okay, so I figured I had 30mins to kill and my work has been caught up for the day... here is the final shot for today... i swear
I increased the jamb sizes, hopefully this will be noticeable.
-
alright, enough for today, my laptop is HOT!
-
Alright, so normally during the weekends I rarely have time to model anything, but this weekend I managed to take a few minutes today to model the rear of the engine...
I'm not 100% satisfied but it's a good shell to work from:
I have to take in a few areas (recess them) to make the controls for the pumps and what have you, but other than that I'm going to spend some time detailing the compartments and such.
-
this is addictive:
-
nice modeling CADken, but i think that the wheel needs more geometry, you can see the edges that form the curved surface
-
here are the compartments covered up with the roll up doors, from both sides...
and with that, good night.
-
just an update:
-
Here's a neighboring townships' engine:
-
You're model is really looking good. As an ex-firefighter I've really enjoyed following it's creation. Keep up the incredible work!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login
Advertisement