My Models (~goldenfrog~)
-
-
Well done!
-
Check it out, and tell me how you think it could be improved! http://sketchup.google.com/3dwarehouse/details?mid=aa16f869a3b36ba0f6c80f6a5291c505
-
Scott Para,
Just as I was about to start missing your commentary!
Thanks for the review on my Nissan. I am aware of the fact that the scale is
is far from normal. That's because while I'm working on my models, I keep 'em huge, so Sketchup doesnt meet it's minimal line length. I believe it's one sixteenth inch. Anyway, If you'd please note that it is a WIP, it is quite open to critism, so you could please tell me what to add, and I'll get right on it.I'm also aware that the wheels are really huge. I'm not sure what to do, becuase the wheels actually look rather good as they are now. I'm certain that they are over the standard maximum diameter, but if I scale them down, they look so strange I give it up.
Is there some particular detail missing?
GF
-
Goldenfrog,
If it is a WIP then it is just that BUT the vehicle does not represent the GT-R is so many ways. Please review the site here this should be MORE than enough detail shots to start getting the model in order:
http://www.nissanusa.com/gt-r/#/photos/exterior-photos/
What throws the wheels off are the super small lug nuts and pattern. Back again we are to if you model to scale you will not have to rescale things later falling into the issues you have now. There is not "minimal length" of lines. If you change your units to decimal and precision to .001 you can draw about as small as you will ever need. So really no excuse to have to draw out of scale. It is a terrible practice to ever draw anything out of scale.
@unknownuser said:
Is there some particular detail missing?
Really?
Scott
-
Scott,
I really appreciated the link. How do you start a model? I've been using ely862me's tutorial for this car, but I can't seem to get it to really look like the GTR. What tips do you have for creating a basic car mesh?
Also, can you tell me how you create seams between panels? Mine always seem too angular.
Thanks SO much for the directions on how to change the minimum line length. I really needed that.
So, the lug nuts are what you think is the real problem...I think you're right about that, but there is also a problem with the diameter of the rims.
Ok, so there are many details missing...
Thanks for the advice.
Froggy
-
-
Look'n good so far! Can't wait to see more progress
-
Thanks Rogue. I gave the hood a shot, but it turned out quite a mess, so I took it out. Today, I'll try again.
-
Must. Continue. Now.
-
Thanks Shams.
I will continue the work this evening when I have some time, right now, back to studies! I'm studying the human heart.
Anything new from you? Besides your museum I mean.
-
Ok, SketchUp time!!
-
-
-
Nice progress. The front end looks a little high. Is that the design?
-
Thanks Ben.
No, the front was not done at the time of that picture. Now it is done, but I'm using my laptop, so tommorow, I'll show you some pictures of the finished front end.
-
-
C'mon, feedback...
-
Nice progress. Still some learning to do with the modeling but its early days yet
-
Thanks, Ben, it's good to have some feedback. The back has been reworked, and some BIG changes made to the front. I'll get some pictures up. My sister gave me some good ideas, such as changing the GT logo into GF.
Advertisement